To mount a bidet in a toilet, initial eliminate the bathroom seat. Affix the bidet’s seat to the catch plate, which is a square opening on the commode. Adjust the bidet’s setting on the commode dish. Screw on the flexible braces. After that, screw on the nut and washing machines. Attach the water system hose pipe to the bidet’s water inlet. Next, affix the 90-degree arm joint end of the hose pipe to the water inlet. First, mount the new installing plate. Align the bidet seat with the brand-new mounting plate. Make sure it clicks right into area prior to tightening the screws. If the system has flexible screws, use them. Once the placing plate is seated, set up the bidet seat. You might need to make several changes. To check if the seat is correctly aligned, rest on it. If essential, readjust the hose or the wingnut. Then, affix the tube to the bidet. Make certain that the tube is attached to the water. Attach the hot water tube to the sink and see to it the T-connectors fit via the holes on the bidet mounting brace. After that, thread the PVC or PEX tubing onto the adapter nut. Once the nut is safe, glide the bidet onto the bracket. The bidet needs to click right into location as well as lock right into place. As soon as you have mounted the bidet, attach the supply of water. When the bidet has actually been attached to the hot water supply, the following step is to install the bidet. To do this, you must have a spare PVC or PEX pipeline and also a 3/8th inch T-adapter. Prior to you link the pipe to the adapter, link the warm water hose to the sink. As soon as the hose pipe is linked to the hot water supply, string the adapter nut onto the PVC or PEX tubing. Feed the tubes via the plastic wingnut hole. Insert the bidet port into the end of the cylinder. Push the wingnut right into location, then push the wingnut into the hose. The t-valve must be placed over the sink to connect the bidet’s water system. After attaching the wingnut to the hose pipe, attach the bidet to the installing plate. Make certain that the bidet’s nozzles line up with the inlet of the toilet. If required, readjust the pipe’s length to prevent it from slipping. If the wingnuts are limited, the bidet is affixed. The bidet placing brace needs to be attached to the t-valve on the commode. Then, the water supply line should be attached to the bidet. If the system already has a water system, the wingnut must be safeguarded to the bidet. If the installation is finished effectively, it must be a straightforward procedure. If you’re not an electrical expert, adhere to the guidelines on the tag.